REQ: J-Link V6 Full firmware

[phasetek]

HI,

I am repairing a broken genuine segger Jlink v6 hardware, already replaced the burned CPU (91SAM7S64AU), but I need firmware for it.  Does anyone have the bin file for V6, preferably a bin file designed for use with sam-ba loader.

Thankx

[Top]

Try this:

firmarmRev6396d.rar
http://depositfiles.com/files/utdiekqgb

[phasetek]

Just tested it, It installs fine and reports v6 full.  Only problem I had is it does not take updates from jlink commander v4.12.  Communication times out during firmware upload and when unit restarts, it comes up with old firmware.  I tried the flash erase pin and reloading samba (clean install) same results.  Only thing during samba programming it asks if you want to unlock regions 1-15 and relock them afterwards, anyone ever done this before?  thanks again for the post/help.

Posted on: March 15, 2010, 02:53:21 14:53 - Automerged
ok, I played with it a little more and got it working.  I flash erased and loaded sam-ba bootloader again, and reflashed this time I told it to unlock regions 1-15 and after flash burn I told it NOT to relock them.  I then ran j-link commander and it auto updated the unit perfectly. Thx again