New plugin for Proton +

[Basicpic]

Hi!
I have created the program - plugin which will facilitate a life to programmers on PicBasic in compiler Proton. I ask you about all discrepancies, remarks and offers to direct me. The adjusting file can be taken here.

[Ahmad_k]

Please post the content of the plugin

[madhan7710]

The plugin is realy very good. Thanks for the wonderful plugin. How about adding 18F series too in the plugin. If 18F also supported then it will be very usefull.

[ajak]

very nice plugin.. Thank you

[bbarney]

heres a little observation from me in the file

[ven67]

Perfectly!!!!! Very good !!!!

[jorge7458]

Hi:
My antivirus report a w32 virus in the zip file
Jorge

[Basicpic]

Thanks for responses. I ask you if will see discrepancies, write to me. With PIC18 I am not so well familiar. The program can in the future will support all microcontrollers which are supported with the compiler.

Posted on: March 09, 2009, 01:44:53 13:44 - Automerged
At me antivirus NOD32, and any viruses there are not present, precisely.

[SONSiVRi]

I was playing with 18F's these days and it's very needed to set correct fuses in those devices.
i.e: running 40Mhz is requires PLL enabled fuses and specifying 40Mhz in proton while using 10Mhz crystal connected to PIC.
And setting names are varying within different 18F's.
It would be nice if main 18F'a are added like 252, 452, 248, 458, 2550, 4550...

[Basicpic]

heres a little observation from me in the file

Thanks for criticism. I shall try to take into account all remarks

[SONSiVRi]

For the triggering edge of TMR0, instead of "forward / back", isn't it should be "falling / rising" ? (SS_2)
And yes, its only spelling, not important.


Same TMR0,
First notation says every 25,6 uSecond but second one says 25,6 second. (SS_3)

[Basicpic]

To Sonsivri:
Excuse, under what conditions at you has come into a fortune in figure SS_03? What frequency, what predivider?

Posted on: March 10, 2009, 04:56:02 04:56 - Automerged
I shall try to correct all marked. Please, leave here all remarks, or me on E-Mail. To add Vref, time is necessary. While leave remarks on all discrepancies, in process of their receipt, I shall correct. Then I shall put the corrected version. My colloquial English is not so good, therefore, if somebody will correct a Help-file I shall be grateful and I shall replace him in the following release of the program with corrections.

[jcsntoll]

Great app.  Thanks for all the work.
I've been looking for something like this..

[Basicpic]

here new version, too rich.
In my view, a useful add-programm for Proton IDE, allowing for a second to create a framework for the program, as well as to calculate the values of registers to work with timers, ADC, USART, I2C, IR-devices. It is easy to calculate the values for the 7-segment displays without leaving the program Proton IDE. It has two language interfaces. To use the program as an add-in, read help first.

[ffr58kk90]

This is really a very good app, if you add support for the 18F series when you have the time it would be perfect.


Ffr